面试专业问题（Interview professional questions）.docVIP

面试专业问题（Interview professional questions） 1. Why is the tap changer of the transformer located on the high voltage side? In the high voltage side, because of the small current on the high voltage side, the capacity of the switch is not high. If the low voltage side, the switch capacity requirements, the volume will be great, because the high voltage side, high voltage, small current, low voltage side, low current. 2, What are the protective earthing resistance, repeated earthing resistance, work grounding resistance, lightning protection and earthing resistance value? The work grounding resistance value and the protection earth resistance value are not more than 4 ohms, the repeated grounding resistance value is not more than 10 ohms, the lightning protection grounding computer resistance is not more than 30 ohms. 3, the use of high voltage circuit breaker: 1) able to cut off or close the no-load current of high voltage lines. 2) can cut off and close the load current of high voltage line. 3) can cut off and shut down the fault current of high voltage lines. 4) with the relay protection, it can quickly remove the fault and ensure the safe operation of the system. 4 what can the disconnector do? : (1) pull together, voltage transformer and arrester. (2) the bypass current of the closing and closing switch. (3) the capacitive current of the equipment is connected with the no-load bus connected to the bus. (4) pull the neutral grounding wire of the transformer, but when the neutral point is connected with the arc suppression coil, the system can be operated only when the system is not in trouble. (5) the following capacity transformers can be operated without load or no-load: The voltage is below 10kV, and the transformer capacity is not more than 320kVA. The voltage is below 35kV, and the transformer capacity is not more than 1000kVA. (6) no-load line with voltage less than 35kV and length less than 5km. (7) an unloaded line with a voltage of 10kV and a length of less