cad导入su（CAD import Su）.docVIP

cad导入su（CAD import Su） Inside each group over a period of time will be put forward this problem, therefore, in a summary of the methods and problems, I hope to help those who encounter problems. My first post, personality is more careless, when you write, there may be many practical problems without writing, and the style is not, I hope you can be understanding and correct. I also used the CAD08 and SU8 Chinese version, location may some translation and options and other different versions. One.CAD processing As the first step and the most important step in the import, the CAD is properly handled and can save much time for the later modeling 1. deletion of superfluous content General CAD integrity of the many things that do not need to go into SU, to retain the original backup, you can delete a lot of content, including text, annotation, terrain, compass and so on. I will keep green road, building three things. 2. elevation, layer and primitive unity After the completion of the above steps, it is the unity of the unity and the elevation of the layer of primitives, which can be done by the [change] command, I used to put everything into 0 layers, line set for the solid line, line width is set to 0, the color is set to 7, pay attention to all the linewidth of multi segment line is set to 0. in some cases the CAD elevation is changed to 0, but there are still highly import SU because the existence of the same thickness, as long as the use of [change] to modify the thickness of it. Here, the need to pay attention to some elements that cannot be identified by SU including the ellipse and so on, if these elements need to export it into the best multi segment line. 3, the problem of exporting After this, they can use the [W] command will need to import the contents of SU in the new block. Of course you can also use the [W] command, but to save the original file, but this is the case for some things need to pay attention to the layer using the [PU] command to clean up. To n