地大《建筑结构抗震设计原理》在线作业一（Ground floor earthquake resistant design principle of building structure）.docVIP

地大《建筑结构抗震设计原理》在线作业一（Ground floor earthquake resistant design principle of building structure） Ground floor earthquake resistant design principle of building structure Total score: 100 test time: - Radio examination A multiple-choice question Radio examination questions (20 questions, 80 points) 1., according to a large amount of data analysis, the exceedance probability of our country within 50 years of design reference period is 10%. A. frequent event intensity B. basic intensity C. rare event intensity D. public value intensity Full marks: 4 2., in urban planning, when the city is in () the earthquake zone, urban construction should consider seismic measures. A. six degrees and more than six degrees B. class six and above six C. seven degrees and more than seven degrees D. class seven and above seven Full marks: 4 The 3. division of the positive and negative factors, the dangerous areas considered are: 1. Geology; II. III. Terrain; landform; IV. Place covering layer thickness; 5. The importance of the building; 6. Basic types, which are (right). A., I, II, III B., IV, V, VI C., I, IV, V D., II, V, VI Full marks: 4 4., the basic seismic acceleration of a region is 0.15g. For the seismic design of the third class building in this area, the following statement is correct. A. according to the requirements of 8 degrees for seismic design, according to the fortification of 7 degrees, take seismic measures B. conducts seismic design at 7 degrees (including calculations and seismic measures) C. according to 7 degrees for seismic calculation, according to 8 degrees fortification, take seismic measures The seismic calculation of D. is carried out at 7 degrees, and the construction measures can be reduced appropriately Full marks: 4 5., in order to improve the ductility of the end of the frame column and the beam column joint during earthquake, the length of the infill area at the end of column should be taken (). A. is not less than 1500mm and long section dimension of colu