中压虹启动方式与高、中压缸联台启动相比有下列优点（The medium voltage starting mode has the following advantages compared with the startup of high and medium pressure cylinder stages）.docVIP

中压虹启动方式与高、中压缸联台启动相比有下列优点（The medium voltage starting mode has the following advantages compared with the startup of high and medium pressure cylinder stages） Medium voltage rainbow start mode has the following advantages compared with high and medium pressure cylinder starting..txt marriage is like wearing a cotton padded jacket for free. It is not convenient to move, but it will be very warm. Falling in love is like peeling onions. Theres always a layer of tears going on. Analysis of starting method of medium pressure cylinder 1.3, the medium voltage starting mode has the following advantages compared with the startup of high and medium pressure cylinder stages (1) start high and medium pressure cylinder start-up to avoid low load high pressure cylinder in wet steam, high pressure to bear high curved thermal stress and torsional stress, low hard cylinder exhaust temperature is higher. Even in warm, high and medium pressure rotor long time in 100 degrees around the metal materials at low temperature brittle zone etc.. (2) MV rainbow start due to the low temperature warm down, medium voltage impulse voltage switch, leaf main steam parameters and wall temperature, improve the past high school cylinder start-up Taiwan impulse, collapse of high pressure rotor life loss limit (3) the starting mode of the medium pressure cylinder is shortened by 4 to 6 hours due to the adoption of early warming, high pressure cylinder and high pressure boring cylinder. (4) start with high and medium pressure cylinder start-up, uniform expansion in unit expansion and high, medium and low pressure cylinder differential expansion is better than the latter, and no jam beating phenomenon, pressure control valve stability, no swing phenomenon. There is no difference between the other safety indicators. Thus, starting with medium pressure cylinder can improve the start-up performance, increase reliability and economy of the unit. Because the starting time is shortened, the machine group is conne