无线路由器桥接的方法（Method for bridging wireless router）.docVIP

下载本文档

3
0
约6.89千字
约 7页
2017-09-05 发布于河南
举报
版权申诉

无线路由器桥接的方法（Method for bridging wireless router）.doc

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
7、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

无线路由器桥接的方法（Method for bridging wireless router）

无线路由器桥接的方法（Method for bridging wireless router） Method for bridging wireless router Network and communication 2009-05-09 23:24 read 507 comment 0: big, medium, small Live in the dormitory of the unit, of course want to use the network resource of the unit. But the computer room is too far away from the dormitory (straight line over 100M), and the line is inconvenient and impossible. So I think of using the wireless router as the bridging method to share the school network. Taobao began looking for wireless gain antenna, but also looked at the N more homemade wireless directional antenna method, but it is not easy to achieve. Until later, with two sets of wireless routing TPLINK54Mb fix remote Internet sharing. The setting is very simple. 1, into the router A settings interface (assuming A is connected to the unit in the room), will be related to the Internet settings, so that the wireless network card book, you can access it through the internet. Assume that A is set SSID:TPLINK (A): IP:54/. Then turn on the bridging function below and enter the B address of the wireless MAC in the AP1 (note that the MAC address of the LAN port must be) 2, enter the router B settings interface (assuming the B is connected to the outside or from the dormitory not far away but can receive the signal emitted by the wireless A, wireless local) are set as follows: SSID:TPLINK (A) must be like A, IP:53/. Then turn on the bridging function below and enter the A address of the wireless MAC in the AP1 (note that the MAC address of the LAN port must be) 3, A, B DHCP are closed 4, access to the computer IP:192.168.1.x (2-200) / gateway: 54 (note that the wireless A IP address) 5, A, B frequency bands should be set as the same. Generally use 6, 11 do not use, because in the test, I found that when opening accounts 108M function, the frequency band becomes optional, it is recommended to use 6, or 1. 6, in order to better speed, the author will be the original 54M wireless A update to 108M, but f