网络工程师考试2008年上半年下午试题解析（Network engineer exam, the first half of 2008 afternoon examination questions）.docVIP

网络工程师考试2008年上半年下午试题解析（Network engineer exam, the first half of 2008 afternoon examination questions） In this paper, by love worldcn contribution DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. This information is provided by the data of students entrepreneurial venture | | business network / Network engineer exam, the first half of 2008 afternoon examination questions A test (a test (15) read the following instructions, answer questions 1 to 3, will fill in the answer sheet to answer the corresponding answer column. [description] a unit has 1 headquarters and 6 branches, each department has its own lan. The unit has applied for 6 C class IP address /24~/24, where the head office and the branch 4 share a C class address. These sectors are now planned to be interconnected by routers, and the network topology is shown in figure 1-1. [problem 1] (4 points) the network uses R1 to R7, a total of 7 routers, using the dynamic routing protocol OSPF. As shown in Figure 1-1, the network is divided into 3 OSPF regions, the backbone area is (1), the backbone area, (2) is the regional boundary router, and (3) is the regional router. Examination questions: questions analysis: OSPF stipulates that the main area must be Area 0. Online web proxy agent | | agent | | weight-loss drug drug list | Taobao best what the best diet pills | slimming drug | This information is provided by the data of students entrepreneurial venture | | business network / A router that has all the interfaces within an area is called a local router. If a router has an interface to different regions, it is called a zone boundary router. Answer: (2), ((3) answer: (1) Area 0, () R3, (), R1, and R2: ( [problem 2] (7 points) Table 1-1 is the IP address allocation table of the router in this system. Please complete the configuration of the following R3 routers as shown in Figure 1-1: R3 (config) #interface e0/1 (en