UG及ProCAST间的网格转换及处理_李小龙.pdfVIP

铸造技术 Vol.36No.3 722 FOUNDRY TECHNOLOGY Mar. 2015 · · DOI: 10.16410/j.issn1000-8365.2015.03.051 UG 与ProCAST 间的网格转换与处理 李小龙，周敦世，冯亮 (湖北新冶钢有限公司中棒线项目部，湖北黄石435001) 摘 要：针对ProCAST 软件的建模与网格划分不强的特点，重点研究了UG 与ProCAST 有限元网格传递的网格 生成方法。 在UG 软件中完成实体模型的创建和网格划分工作，然后通过提取网格文件信息中的节点和单元信息编写 成数据转换程序，将网格模型传递到ProCAST 前置处理模块中进行后续处理。 该方法成功地解决了大型复杂铸件及复 杂模具的网格剖分问题，并且网格生成质量好，成功率高。 关键词：网格划分；数据转换程序；接口； ； UG ProCAST 中图分类号： 文献标识码： 文章编号： TP391 A 1000-8365(2015)03-0722-05 Mesh Transform and Transaction Between UG and ProCAST LI Xiaolong, ZHOU Dunshi, FENG Liang (Department of Medium Steel Bar Project, Hubei Xinyegang Co., Ltd., Huangshi 435001, China) Abstract ： Aimed at the features that ProCAST software is not strong in modeling and meshing, the method of mesh transmission between UG and ProCAST was studied. The solid model generation and meshing works were conducted in the UG software, the data exchange program was written through picking up the nodes and elements information, which were transmitted to preprocess module of ProCAST for next process. The method was successful in solving the mesh problem of large-scale complex casting and die. And it can create high quality mesh and has high success ratio. Key words ： meshing; data exchange program; interface; UG; ProCAST 近些年来，许多铸造数值模拟软件CAE 得到了 众多学者在铸造数值模拟软件的实体建模和网