analysis of the quality of electrical engineering problems and countermeasures（电气工程的质量问题的分析和对策）.doc

Analysis of the quality of electrical engineering problems and countermeasures 2.4 Ground Lightning deal Through reinforcement of the foundation slab, columns and floor reinforcement welding, corrosion, ground resistance testing to do and whether it meets the specifications and design drawings if necessary increase the artificial grounding to reduce grounding resistance value to connect the ground wire, ground terminal of the reserve should be consistent with regulatory requirements, exterior doors and windows of metal, the metal protective railings and roof large part of the mine as a key, to improve convergence process, to prevent the omission, ground equipment enclosure should be improved, when using the column bars do lead off-line, you must have a top-down reinforcement deflectors mark, when using special deflectors, attention should be up and down through into one, and do welding, anti-corrosion treatment. 2.5 hidden control works In electrical engineering the construction process, there are a lot of cable management, grounding wire must pass through floors, walls, or other buildings, and buildings will have ground floor flat steel, basic channel, such as welding and if wrong, not only rework difficulties, but also lay hidden, it must strictly monitor the quality of hidden works. embedded pipe material type specifications meet the design requirements, the tube is arranged in neat, bend radius compliance with regulatory requirements. cable, bus model specifications meet the design requirements , power cables, control cables are laid separately, shielded cable is required, compliance with national installation standards. to prevent the embedded tube is blocked, ground wire and cable is damaged during the construction process in the construction, supervision and site inspections to be used, on-site observation, measurement and inspection records to ensure construction quality installation. Measuring ground resistance should be less than equal to th