4模板技术交底记（4 template technical notes）.docVIP

4模板技术交底记（4 template technical notes） Technical disclosure records Table B2 number B2-003 Project name Qisen real estate development company Qisen apartment on November 5, 2003. Abstract: Related materials, reinforced masonry structure binding machine preparation. The quality requirements and construction technology. Work content: (including in the project of key technical issues for the construction; ensure the construction quality of the construction methods, technical measures and relevant provisions; safety measures; quality standard and code for acceptance of construction drawings must be noticed in size, elevation, axis and embedded parts, reserved hole position; case; design changes in the quality and safety of operation requirement) A, construction preparation (a) operating conditions 1, play the wall 50 cm horizontal line, check whether the brick position meets the requirements for pre screening procedures. 2, structural column steel banding is completed, and run the inspection procedures implicit. 3, check whether the column structure is clean, including brick tongue ash, mortar and steel column roots hanging on the ground ashes. (two) the material requirements Stereotypia combination steel template (length 600 cm, 750 cm, 900 cm, 1200 cm, 1500 cm, width 100 cm, 200 cm, 300 cm), yin and yang angle template should be smooth and clean. 50 x 100 wood pine wood, 2440 x 1200 12 thick bamboo plywood. 60 ~ 80mm nails. (three) the main equipment Electric drill, spanners, pliers, hammer, planer, disc squat, etc.. Two, quality requirements 1, the template installation (1) the main control project 1) the upper formwork installation of cast-in-situ structure and support, the lower floor should have the capacity to bear the upper load, or a column bracket; the upper and lower support should be aligned, and laid plate. 2) in brushing template isolation agent, no contamination of steel and concrete joint. (2) general project 1) template installation shall meet the followi