ct维修（CT maintenance）.doc

ct维修（CT maintenance） Keywords: CT; fault maintenance; The basic structure and working principle of the 1 CT The basic structure of 1.1 CT Although there are many kinds of CT, the hardware is basically the same, including scanning part, computer system, image display and recording system and central console. Grasp these basic structural characteristics, there is a basic direction and basis for the analysis and judgement of the CT fault. The working principle of the 1.2 CT CT is mainly composed of X-ray tube with different number of sensors, used to collect information. X-ray beams were scanned for the selected layers, and their strength was correlated with the density of the tissues, resulting in corresponding absorption and attenuation. The detector will collect X-ray signals into electrical signals, the analog / digital converter (a/d converter) into a digital computer input, storage and processing, so as to obtain the level of the unit volume of the CT value, and arranged in a digital matrix (digital matrix). These numbers can be stored on hard disks, floppy disks, and magnetic tape. They can also be printed by printers. The digital matrix is converted to an image on the monitor by a digital / analog (d/a) converter, which is a cross-sectional image of the layer. Images can be taken with multiple cameras on film for reading, archiving and consultation. 2 common faults of CT 2.1 mechanical parts of the fault The mechanical failure mainly increases with the service life year by year. In the early stage of CT, due to the positive rotation and reverse rotation, the rotation acceleration constant deceleration deceleration was repeated in a short period of time, and the mechanical failure rate was higher. Often manifested as speed instability, easily out of control, resulting in spin, brake, crash, belt too tight, loose, and cable wear and tear and other faults. Today, most CT use slip ring technology, one-way uniform rotation, and some high-end machines also use magnet