kailufangan（kailufangan）.docVIP

kailufangan（kailufangan） In scheme Furnace construction will be completed, the production will be the primary task, especially in work is more important. In general is divided into two stages, one is the baking and roasting electrode, two feed production of qualified products. The purpose of the oven is to remove the moisture and gas in the lining; to roast the electrode; to make the lining to accumulate enough heat to achieve the better thermal stability of the furnace; to meet the requirements of smelting. Oven and baking electrode In order to speed up the baking process and reduce the cost of baking, the oven and the baking electrode are simultaneously carried out by adopting an electric baking furnace. 1, the first comprehensive examination of various equipment complies with the test requirements: power supply system, electric control system (busbar system, instrument and meter, PLC), water cooling system, electrode control system, electrode pressure system, suspension system, electrode with insulation system, feeding system, gas purification system, furnace system, calcium carbide crushing system. 2, after the equipment inspection normal, makes the electric stove transformer no-load 24 hr. 3. Charging: 1) in the bottom of the three-phase electrode is lower for? 1500 x 1200 x 6 mm coke drum Zhuru shown in figure -1, with 5 ~ 30 mm Lantan?. 2) as shown in figure -2 production of calcium carbide and masonry bottom channel false door (its main strong guarantee in the start-up period does not collapse, no leakage). Material: ordinary building brick 700;? 1500 to 250 mm (6 log root length of 1300 and 2600 mm and three root). 3) with charge: first in the bottom filling? 5 ~ 30 mm Lantan, thickness of 200 mm (about 6 tons); then according to the normal charge (Figure -1 filling materials according to laboratory ingredients). 4) with a grain size less than in the three-phase electrode shell? 100 mm qualified electrode paste, its height is decreased when the electrode to