lte学习笔记（lte学习笔记）.docVIP

lte学习笔记（lte学习笔记） A. 1. PCI: cell site, PCI is the physical cell ID, from the physical layer, PCI (physical-layer Cell identity) is a primary synchronization signal (PSS) and secondary synchronization signal (SSS) which can be obtained by a simple operation. The formula is as follows: PCI=PSS+3*SSS, the PSS value is 0... 2 (actually 3 different PSS sequences), the SSS value of 0... 167 (actually 168 different SSS sequences), using the above formula PCI range is from 0 to 503, so... There are 504 PCI in the physical layer. The 2. RSRP: power frequency value (reference signal received power level, the base station transmit power; RSRP), is a district public reference signal received to the terminal (CRS) power value, numerical linear measurement bandwidth of single RE power mean value is reflected in this area of useful signal strength. 3. RSRQ: (reference signal receiving quality), the ratio of RSRQ is RSRF and RSSI, N times RSRQ=N*RSRP/RSSI, where N denotes the number of RE contains the measurement bandwidth in RSRI, can reflect the relative size between signal and interference. 4. RSSI: (received signal strength indicator), RSSI is all the received signal terminal (including the same frequency and useful interference, adjacent channel interference, thermal noise power) linear mean value, reflects the strength of the load on the resource. 5. PDCCH UL Grant Count: 6. PDCCH DL Grant Count: 7. Average SINR: (signal to interference plus noise ratio, interference signal and the received signal strength of the received (noise and interference) intensity ratio.) SINR, is the ratio of signal power and interference and noise power and the direct reflection of the quality of the received signal, the transmission efficiency is. 8. Transmission: Mode (transmission mode) a total of 8 species, TM1 said the data transmission of single antenna transmission diversity (TM2, said 2 antenna transmits the same data in a wireless environment (RSRP and SINR difference), under the condition