rs485（rs485）.docVIP

rs485（rs485） Electrical characteristics: 1. RS-485 logic 0 to two line voltage difference between + (2 - 6) V; logic 1 to two line voltage difference between the - (2 - 6) V. Interface signal level lower than RS-232-C, it is not easy to damage the interface circuit of the chip, and the level and the level of TTL can be conveniently connected with TTL compatible circuit. The highest rate of data transmission of 2. RS-485 10Mbps 3. RS-485 interface is using a combination of balance driver and receiver, antiinterference capability enhancement, which is of good anti noise interference. The maximum communication distance of 4. RS-485 is about 1219M, the maximum transmission rate is 10Mb/S, the transmission rate and the transmission distance is inversely proportional to the transmission rate of 100Kb/S, it can achieve maximum communication distance, if need to transport a longer distance, need to add 485 repeaters. RS-485 Bus supports a maximum of 32 nodes, if you use a special 485 chip, can reach 128 or 256 nodes, the largest can support up to 400 nodes. Edit this section first serial interface Because the RS-485 interface has a good anti noise interference, long transmission distance and multi station ability has the advantages that it has become the first choice of the serial interface. Because the RS485 interface is composed of a half duplex network, generally only two connections, so RS485 interface adopts shielded twisted pair transmission. RS485 interface connector uses 9 core socket DB-9, and intelligent terminal RS485 interface using DB-9 (hole), RS485 keyboard interface and keyboard connected with DB-9 (pin). Edit this paragraph RS485 interface The electrical characteristics of RS-485: Logic 1 to two line voltage difference between + (2-6) V; logic 0 to two line voltage difference between the - (2-6) V. Interface signal level lower than RS-232-C, it is not easy to damage the interface circuit of the chip, and the level and the level of TTL can be conveniently co