vga线接法（VGA line connection method）.docVIP

vga线接法（VGA line connection method） Multimedia information publishing, advertising, building VGA interface pin map (Kong Zuo): The VGA pin definition and VGA welding line The corresponding signal corresponding to the welding pin number 1 red red red wire 2 green green green line core wire The core 3 blue color blue blue line 4 address code ID Bit 5 self test Red red shield 6 The green line shield 7 Blue blue line shield 8 9 reservation 10 digital black line 11 address code brown line 12 address code The 13 line synchronous yellow line 14 synchronous line 15 address code The outer shield shell D15 terminal crimping There is a very suitable welding method is in D15 5~10 at both ends of the pin welding in public together, red, green and blue shield wire twisted together to the public on the ground; 1, 2, 3 feet with red, green and blue wire; 13 yellow line; 14 white lines; the outer shield shell D15 terminal crimping. The method is as follows: to prepare a 15 pin hole or joint VGA, the definition of each pin is as follows (VGA connector labeled): 1PIN - Red, 2PIN, Green, 3PIN, Blue, 4PIN, ID Bit, 5PIN, N/C, 6PIN, R.GND, 7PIN, G.GND, 8PIN, B.GND 9PIN, No.Pin, 10PIN, GND, 11PIN, ID Bit, 12PIN ID Bit, 13PIN H Sync, 14PIN V, Sync, 15PIN, N/C 1, 2, 3 for the simulation of the red, green and blue signals is 3 thick lines, 6, 7, 8 for the corresponding analog ground both the corresponding shielding line; 13 and 14 for the digital signal into a digital field, 10; ID Bit to control or address code between the screen and the host. In practical engineering, often appear in the wrong wire connection, if some of the foot (such as 4, 5, 9, 15) received on the ground, to display the application does not have what problem, but if 10 feet off ground, it must not appear the ground therefore, if the use of this kind of joint is recommended to measure, look at each others definition is the same, of course, sometimes in order to avoid this situation, some devices will not pin all the ground