伍尔特底盘装甲（The chassis armor）.docVIP

伍尔特底盘装甲（The chassis armor） Brand: Wuerth A composite of rubber and plastics without any asphalt. Used for anti rust and sound insulation of new car bottom. Permanent elasticity, impact resistant flying off! The German Wurth market is now the best selling chassis armor It is oily antirust glue for vehicle chassis, damping and anti rust chassis, permanent elasticity, impact resistant flying off - due to the resistance of stone do not fall off, can avoid the erosion of water and salt, significantly reduced the flying sand hit the vehicle noise, can protect the steel from rust The car, because the road is not smooth, which can significantly reduce the chassis resonance noise, and reduce the noise and isolation The rubber and polymer materials, excluding asphalt composition It can spray the chassis, front and rear skirt, lower threshold, round arc, wave plate, hood and trunk The 1 - 2 hours after painting. To accelerate drying, it can be heated to 80 degrees C The spray after flowing and shedding, permanent elasticity, scratch resistance, no rust Scope of application: used to protect the body chassis, front and rear skirts, the lower part of the threshold, wheel arc, wave board, engine hood and trunk and other parts Directions for use: fully shake before use. Thoroughly clean the chassis of the vehicle to ensure clean, dry, rust free, oil-free. Apply to the bottom of the blank. The surface 20-30cm is sprayed. Please allow a certain amount of time for each layer to be dry enough for multi-layer spraying. It is recommended that a layer be applied before the formal operation to improve the adsorption capacity. Note: please check the performance of sprinkler irrigation before use. After use, turn the nozzle until the nozzle is no longer ejected. Do not apply on the connection, the engine, the drive and the brake. Use shall not be forced to dry German wvrth group company (Adolf W RTH GMBHCo) German wvrth group company (Adolf W RTH GMBHCo) founded in 1945, engaged in the hardw