使用混合域示波器查找无线嵌入式系统中的噪声来源（Finding sources of noise in wireless embedded systems using mixed domain oscilloscopes）.docVIP

使用混合域示波器查找无线嵌入式系统中的噪声来源（Finding sources of noise in wireless embedded systems using mixed domain oscilloscopes） In the radio chip or module integrated into a typical embedded system is a common task facing the designer must track and eliminate the noise and spurious signal. Including the noise sources of potential: switching power supply, digital noise, from other parts of the system and external noise sources. In considering the noise, also should consider any possible interference generated by the radio, this is to avoid interference with other radio and meet an important consideration and regulatory requirements. We measured the radio spectrum centered at 868 MHz, with 2 kbps FSK modulation data rate is quite low, for reference. Figure 2 shows the reference spectrum. Note that the MDO time domain and frequency domain simultaneously display view view, all signals are time related. You can move the data acquisition time spectrum (Spectrum Time), RF spectrum study what changes over time. In Figure 3, we placed spectrum time display signal spectrum packet preamble multiple symbols transmitted during the. Time is the spectrum bandwidth support analytical spectrum picture of hope (RBW) the number of the required time. It is equal to the window shaping factor divided by RBW. The default Kaiser Window plastic factor is 2.23, in this case, the spectrum of time was 2.23/220 Hz, about 10 ms. There is only one FSK modulation frequency of RF signal, we use the long acquisition time spectrum, to measure the bandwidth and total power. To easily see the radio transmission of packets, we added a RF curve with time changes in the temporal view. Marked orange curve A shows instantaneous amplitude changes with time from RF. Marked orange f curve shows with the instantaneous RF frequency picture center frequency changes with time. The green curve (Channel 4) to the current display module. You can see from the current data packets between close to 0 up to about 40mA during transmissio