印刷中拉毛现象产生的原因及控制（Causes and control of produce galling phenomenon in printing）.docVIP

印刷中拉毛现象产生的原因及控制（Causes and control of produce galling phenomenon in printing） Galling phenomenon is one of the common faults in printing. In the process of printing, printing plate or blanket ink, in a very short moment stamping part of the transfer to the surface of the paper, then the separation, separation, if the surface strength of ink stripping force is larger than that of the paper, fine fiber, ink layer will peel off paper glue, paint and other particles, the surface to produce visible rupture of fluff foaming phenomenon serious, may produce a strip of paper. The influence of szlama on Printing Galling phenomenon will cause the graphic part of the pollution, affecting the quality of printing products. On the one hand, the paper was stripped of the position of the particles due to transfer ink and white spot; on the other hand, was stripped of the particle after transfer blanket adhesion to the plate, the first contact with the rotation and fountain solution by wetting plate. In the process of subsequent contact with ink in the ink so that the rejection, no ink plate graphic part, causing the printing surface of large white. Or stripped of small particles at first did not be found, will be printed with the accumulation of blankets and plates in the surface, resulting in plate wear, increasing the number of times the rubber blanket cleaning. Some small particles can even move into the ink trough and sink, making printing impossible. Two, analysis of the causes of galling phenomenon In the brief moment of imprinting, there is a very complex force between the ink, the paper, and the blanket. The viscosity of the ink itself creates an adhesive force on the surface of the paper when it is separated. Rubber blanket is also viscosity, the same will produce adhesion. The interaction between the three inks, paper, and rubber sheets also yields a peel tension. If you do not meet, is napping, affect the printing quality, increase the frequency of cleaning blanket. Three