叉车操作步骤)（Forklift operation procedure)）.docVIP

叉车操作步骤)（Forklift operation procedure)） Forklift operation steps On the front of the car, a self check (before starting the engine and operating forklift note) 1, through the theoretical study and the forklift performance and structure characteristics and considerations are clearly understood, be familiar with the location and function of the joystick and instrument. 2, according to the provisions of check the tire pressure, clearance between the tread inlaid stones and insert. 3, check whether the water in the water tank to fill, engine oil level scale, fuel tank oil, and the oil pipe joint, a pipe joint has no leakage phenomenon. 4, check the clutch pedal free stroke is normal. 5, check whether the normal work of the pedal. 6, check the fuel supply line if there is air, if the air standard should be excluded. 7, check the electrical system, there is no bad contact, short circuit phenomenon. 8, check the headlights, lights, lights, brake lights, turn lights and speakers are working properly. 9, check the fastener loosening. Two, start the engine 1, the intermediate gear control lever in (neutral) position, the hand brake in the braking state, insert the start switch key, in a clockwise direction to warm up position, hold for 5 seconds, and then go to the starting position at the same time, gently step on the gas pedal and the clutch pedal, the starting time should not exceed 10 seconds after starting immediately after the release, the key is automatically reset, if the engine can not start again, should be every 1-2 minutes to restart. 2, when the temperature is below 5 DEG C, if the starting difficulty, can use the preheating system, starting when the start switch key to the warm-up position, for 45-60 seconds, and then back to the starting position, can start, if not starting, the interval should be 2 minutes, will switch back to warm up position, repeat the above process. Three, inspection and preparation before driving 1, after starting the engine should be abou