发动机拆装（Engine dismounting）.docVIP

发动机拆装（Engine dismounting） Engine disassembly and maintenance information database universal Buick skylark, Oldsmobile - archio, Pontiac - Am engine mechanical system Engine disassembly First, the disassembly and assembly of engine Warning: instant engine in the flame, the fuel system still exists pressure. 1. 2.3L and 2.4L engine The engine and transaxle for removing one. 1) remove the oil pressure of the fuel system, disconnect the battery anode ground wire. 2) release cooling liquid cooling system, if equipped with air conditioning (A/C), the recovery should be frozen liquid. 3) remove the left sound insulation board, and remove the clutch pedal from the push rod (only drive axle for manual transmission). 4) remove the heater and remove the hose on the radiator hose from the thermostat housing and remove the air filter air tube to solar term door, remove the radiator and cooling fan bracket assembly. 5) if equipped with air conditioning (A/C), you should remove the coolant pipe, abandoned O ring. 6) from the front of the engine, remove the vacuum hose from the electrical parts, remove the plug, and mark. 7) remove the vacuum brake pump tube, remove the solar term door pull, remove the cable bracket. 8) remove power steering pump and power steering pump, remove with pipeline pump. 9) remove the fuel line, and plugged. 10) from the variable speed drive cable bridge door solar term remove shift cable and automatic transaxle. 11) remove the exhaust manifold and a thermal insulation board. 12) remove the lower radiator hose and remove the coolant and remove the recycling container. 13) installed on the engine support tool J-28407-A or alternative tools, remove the right engine bearing. 14) safe lifting and a prison car, the oil pan oil drain. 15) remove the front wheel assembly, remove the lower right fender. 16) took out the plug of ABS wheel speed sensor, remove the variable speed drive ground on the bridge. 17) remove the cotter pin and slotted nut from the lower ba