变频器实现分条机张力控制的原理及应用1（Principle and application of frequency converter to realize tension control of bar splitting machine 1）.docVIP

变频器实现分条机张力控制的原理及应用1（Principle and application of frequency converter to realize tension control of bar splitting machine 1） Inverter Slitter tension control principle and Application 2007-6-8 11:07:00 network reprint collections of feeds Abstract: This paper mainly introduces the purpose and process of the sub machine, control mode, control difficulty and debugging method and process. This paper focuses on how to use the delta V series inverter to realize tension control. The debugging procedure and parameters should pay attention to application of V series frequency converter to realize torque control when setting. Key words: Delta strip tension control inverter 1 Introduction Adhesive tape, protective film production equipment mainly includes various adhesive products and non adhesive paper, cloth, leather and plastic materials glue, multilayer laminating, slitting, rewinding, slitting, punching machine etc.. The points of the machine according to the different needs of material cutting, cutting in the production process. The points of the machine (Figure 1) is mainly used to cut into narrow wide coil coil. The process includes unwinding and rewinding process two. Unwinding and tension control is the key link of automatic roll slitting machine. Program features of this case is based on the original electronic control system using frequency converter to realize reeling torque control, to achieve the desired results, on the basis of the original work to improve the machine performance, makes the machine more stable in high speed operation, convenient operation, safety and reliability, durability, reduce labor intensity. 2 system analysis Reeling process requires constant tension control. The tension given by the tension controller. The principle of tension controller is calculated by measuring the roll diameter rolling line speed, load torque (=F * D/2 F D for the current setting tension, coil diameter), so when setting the size of the tension, because the current t