吊顶施工（Ceiling construction）.docVIP

吊顶施工（Ceiling construction） 6 ceiling Engineering 6.1 general provisions This chapter applies 6.1.1 quality inspection to the dark ceiling, the ceiling a project. Explain： 6.1.1 this chapter applies to the keel with the decorative panel of the ceiling project. According to the different construction process, and dark keel and keel ceiling. 6.1.2 ceiling project acceptance should examine the following documents and records: 1 ceiling engineering drawings, design specifications and other design documents. 2 Certificate of material products, performance test reports, site acceptance record and retest report. 3 concealed engineering acceptance record. 4 construction record. The formaldehyde content of wood-based panel with 6.1.3 ceiling engineering for re inspection. 6.1.4 ceiling project to deal with the following hidden project acceptance: 1 ceiling installation and water piping and equipment pressure test. 2 wooden keel fire prevention, anti-corrosion treatment. 3 or embedded parts of tie bar. 4 rod installation. 5 keel installation. 6 filling material is provided. Explain： 6.1.4 in order to ensure the safe use of ceiling engineering, and ensure the completion acceptance without damaging the finish, concealed engineering acceptance of ceiling engineering is very important, this article listed sections shall be provided by the record concealed engineering acceptance of supervision engineer signature. 6.1.5 sub project inspection group should be classified according to the following provisions: The same kind of ceiling project each of the 50 rooms (large rooms and corridors in area 30m2 is a ceiling) should be divided into a test group, less than 50 also should be divided into a test group. 6.1.6 check number shall comply with the following provisions: Each test should be at least 10% batches of checks, and shall not be less than 3; under 3 should be fully checked. 6.1.7 installed before the keel, should according to design requirements of the room, the elevation and th