刮板输送机（Scraper conveyor）.docVIP

刮板输送机（Scraper conveyor） Code for safety operation of scraper conveyor drivers Author: anonymous source: the original hits: 104 update time: 2009-7-5 Scraper conveyor driver I. requirements for starting a job First scraper conveyor scraper conveyor driver must be familiar with the performance and structure principle and operation rules, master conveyor general maintenance and troubleshooting skills, understand the basic knowledge of mining and roadway supporting, through training, examination, obtained the operation qualification certificate, be certified. Two. Safety regulations In the second working range of the top of the top to endanger personal and equipment safety, must promptly report, after processing, square accurate operation. Near the third motor and switch location within 20 meters in the air gas concentration reached 1.5%, you must stop, cut off the power supply, the withdrawal of personnel, for processing; tailentry in the wind of the gas concentration exceeds 1% or more than 1.5% when the concentration of carbon dioxide, must stop operation, the withdrawal of personnel, processing. Fourth, strictly prohibit pedestrian pedal scraper conveyor. When using the material specified by the scraper conveyor, such as operation rules, the safety measures for preventing the top and top of the scaffold must be strictly enforced. Fifth drive scraper conveyor must be issued before the drive signal, confirmed that the staff have left the rotating parts of the machine, issued an early warning signal or point two times before the official start. Sixth, troubleshooting and handling scraper conveyor, you must cut off the power supply, lock control switch, hang the power failure card. Seventh, pinch, chain, point action, the staff must hide from the force direction of the chain; normal operation, the driver is not allowed to face the direction of scraper conveyor, so as not to break the chain wounding. Eighth remove the hydraulic coupler plug, fusible plug, explosion-proof