发的（Hair）.doc

发的（Hair） 1, boot is not started, the LCD screen does not display Reasons: 1, 220V AC power output problems; 2, 24V motherboard power supply without output; 3, memory, display failure; Solution (1) change the output of 220V power supply, measure the main board, power board, voltage should be 24V, current should be 12.5A. (2) unplug the display line and button on the main board and restart it. (3) if the problem has not been solved after the first two items, please replace the main board. 2, (1) the machine starts normal, the display does not show; (2) show normal, the button is not working; Reason: (1) the main board display contrast problem; (2) the key line is not connected; (3) button aging; Solution (1) adjust the contrast of the main board display screen; specific operation method: set menu - user settings - LCD display contrast, and then adjust up and down, confirm to save. (2) the button should be aligned with the main board and inserted in the mouth. (3) change the button for the screen 3, print width is not enough The reason: (1) paper partial or "margin" normal surviving ". (2) grating problem. Solution: (1) use paper jam to prevent paper from going astray. (2) the "marginal surviving" to extend or re initialization settings can be again. (3) change one of the original gratings. 4, print length is not enough Reason: 1, the speed of moving the paper system or bracket is too slow or slow. 2, motherboard calibration settings are not saved. 3. Use calipers to measure the outer diameter of the paper wheel. Solution: (1) adjust the bracket speed value to the optimum condition (2) longitudinal axis test; specific operation method: in the main menu, select "auxiliary function menu" drawing, vertical axis test print. The actual value of the mapping is instead of the original value 83.82CM. (3) the outer diameter of the paper wheel should be 64.3CM, big, long and short 5, in the printing process, ink or ink droplet breakage phenomenon, but after the suspension or smo