依玛壁挂炉补气方法（Method for air supplementing of immergas hanging stove）.docVIP

下载本文档

4
0
约6.94千字
约 6页
2017-09-07 发布于河南
举报
版权申诉

依玛壁挂炉补气方法（Method for air supplementing of immergas hanging stove）.doc

1、本文档共6页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
5、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
6、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
7、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
8、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

依玛壁挂炉补气方法（Method for air supplementing of immergas hanging stove）

依玛壁挂炉补气方法（Method for air supplementing of immergas hanging stove） Wall hanging furnace recently buck, more severe, that is cold water 1.2ba, burn 70 degrees, more than 3ba. There was no such thing before, and some people on the Internet said they wanted to add gas. Repair phone calls, immergass gas, get it. In fact, relatively simple, we can also add to the province to send money to them. Concrete operation: 1, turn off the wall hanging stove, turn off the inlet valve, the heating water. That is the 3 valve on the right hand side. The outlet valve of the hot water is on. 2, open the following water switch (this is my guess, because I can not see whether the maintenance master is open or closed) 3, open the kitchen hot water faucet (that is, the tap out of the wall furnace hot water), there will be water running out. 4, move a chair, with an air pump, (should be the bike that the new type of valve without the valve core), to the top right corner of the wall hanging furnace, there is a place to cheer, as if to first unscrew a small lid. I didnt go up to see it. Fit the inflator. 5, start pumping, hot water will continue to have a small amount of water out. Until the water does not come out. Remove the pump and remove the chair. 6 at this time the hydraulic pressure gauge is zero. 7. Turn off the hot water tap. Close the make-up valve. Switch on the 3 water valve. 8, open the replenishment valve, water to 1.2ba. Turn on the wall boiler. The actual operation of the operator is to turn off the hot water tap, slightly open the intake valve, water pressure to 1.2ba, and then close the inlet valve, turn off the water supply valve, and then open the inlet valve and the heating inlet and outlet valve. Now heating water, the actual boost less than 0.3ba. That is, start 1.2ba, burn about 70 degrees 1.5ba. We can refer to. In fact, the boost is to inflate the expansion tank inside the wall boiler and drain the water out of the expansion tank. Where is the expansion tank in the f