原理实训（Principle training）.doc

原理实训（Principle training） Introduction First, fill in the blanks (1 points per minute, 10 points) 1. chemical unit operation training has _ engineering characteristics, device is complex and some commonly used ________ measuring instrument ____, so technical preview is particularly important. 2. before training to the training room for __ site preparation, and training projects to write __ preview report, no preview report shall not participate in training. 3. students entered the training room, must be approved by the examination _ request to teacher questioning _ only allowed to participate in training. 4., training should be in strict accordance with the operating procedures (ie, open, stop procedures). Especially some important __ the opening and closing of the valve can not be reversed in the training sequence, not free to open and close the valve and a _ _ button __________. The instruments and equipment problems should immediately stop at the parking step _ found 5. training process, and report the instructor. 6. specific content for training, each training after the write _ __ training report. 7. training report should be written in concise, __ data and charts __ complete, clear and correct conclusion, discussion and comparative analysis. Two, questions and answers (5 points per subject, 2 questions, 10 points) 1. before training, should go to the training room for on-site preview, and according to the training project to write preview report, no preview report, not to participate in training. What parts does the preparation report usually include? Answer: 1. name of project training; the training objective; the brief principle (scheme); the sketch training device or process; the training steps (points at the same time to consider matters needing attention); the operation form related data records (taking into account the data distribution) 2., for training specific content, each training should be written after the end of the training report. What does the r