coolpro用法（Coolpro usage）.docVIP

coolpro用法（Coolpro usage） The installation of CoolEdit pro, 2, the plug-in installed into the installation directory directory, create a folder called DX, all the plug-ins are installed to release here. 2, after opening CoolEdit Pro 2, will automatically establish a new project. The interface is as follows: As you can see, the Red 1 is the multi track and single track switching button. Red label 2 means you should light R in R, S, M when recording, which means that the track is in the recording range. Click on the recording key (red label 3) to begin recording your voice. You need to adjust your audio and audio properties before recording, as shown in fig.: You need to tick the recording item, select it in the MIC column, and dont choose anything else, because we want to record only the sounds we want to sing. 3, in the third rail at the light R, click the record button, dont make a sound, the first recorded file under a blank noise, does not have to be long, after recording the double click to enter the single track model, choose the effect of noise elimination, noise reduction, noise sampling selection, click close. Back to multi rail mode to remove this rail. You can also intercept tracks in the lower part of the tracks to obtain noise for noise reduction. 4, right click on the first track, insert an audio file, note that this audio file is your music accompaniment file, can be MP3, or can be wav and other music files format. 5, in the second track, R lit, click on the following red recording key, you can begin to sing. Dont forget to prepare the lyrics and know the melody of the song, Or something else, but........ Hey 6, after the recording is complete, you can listen to your recorded voice is not dry? Is it hard to hear? Ha ha, all this, without any effect. OK, now lets polish your voice. Right click on the track where you recorded the sound and click Edit waveform to enter the single track mode. Figure 7, we record the sound first to noise reduction, although