cvt自动档开车技巧（CVT automatic drive skills）.doc

cvt自动档开车技巧（CVT automatic drive skills） 1 dont pull the gear lever to the N gear when driving. 2 move backward from the forward, then stop the vehicle from the rear of the gear, and change the gear lever while treading on the brake pedal. Otherwise, the gearbox will be damaged. 3, the downhill should be used S or manual mode of low-end, the use of the engine brake function, to avoid long braking, brake shoe heat decline, make brake performance worse. 4 because of the structure and working principle of CVT, all the control is done by internal hydraulic pressure. Therefore, the quality and quantity of CVT shall be checked in accordance with the time limit specified by the manufacturer, and the oil shall be changed regularly to meet the requirements of the manufacturer. 5, in order to maximize its fuel economy, it is best to use the CVT transmission automatic mode. In this way, the engine and the transmission can be kept in the state of optimum matching, and the maximum torque and power output of the engine can be used to achieve the economic speed, thereby improving the fuel economy. 6, because of the structure of CVT, if the relevant components and circuits are checked or powered off, a special setting program should be carried out inside to make the CVT display its normal state. Therefore, relative to CVT transmission gearbox maintenance, should go to the specialized repair unit to carry on the maintenance. P, parking gear R, reverse gear N, neutral D, drive gear 3, 2, 1 fingers force the transmission to be limited to one gear, for example, 3 is to limit the transmission to below 3 gear. Well, remember that, its important. If you know how to stop, reverse, drive, and neuter, its easier to remember the symbols of those gears. The opening of an automatic car: First of all, do not push the gear lever, do not force, more than 99% may be what you did wrong. For example, the SO car has a tie rod under it to pull it out of the P or push it into the P. On the Polo, it is the