高速线材工艺设计教案.doc

辽宁科技大学本科生毕业设计(论文) 第I页 高速线材车间工艺设计及帘线钢质量控制技术 摘要 本设计是依据鞍钢线材厂设计的年产量55万吨的高速线材车间工艺。典型产品为 Q235、Φ6mm的线材。设计说明书包括文献综述，车间工艺设计，专题三个部分。在综 述部分叙述了线材的基本知识和当前线材生产的状况。设计部分（从第二章到第九章） 主要包括产品方案及工艺流程的设计及制定、生产设备的选择、工艺参数的计算及校核、 年产量计算、导位装置及轧机调整、车间平面布局设计及图纸绘制，还有技术经济指标 与环保措施。专题部分主要阐述了对帘线钢质量控制的方法及研究。 关键词：高速线材；生产方案；孔型设计；校核；帘线钢  辽宁科技大学本科生毕业设计(论文) 第II页 High-speed wire rod plant process design and quality control of steel cord Abstract This design which is based on Anshan Iron and Steel Wire Factory is planted 550,000 t annual workshop for high-speed wire rod plant technology. Typical produce is the Q235, Φ6mm wire. Design specification includs literature review, workshop process design and project. The literature review part describes the basic knowledge of wire rod production and the current situation. Design part (from chapter to chapter IX) describes the main program and the process of product design and development, production and equipment selection, process parameter calculation and checking, annual basis, the guide position adjusting device and mill, shop flat design and layout drawings, as well as technical and economic indicators and environmental protection measures. The major topics describes method and technology in quality control of steel cord. Keyword：High-speed wire; production program; pass design; check; Steel Cord  辽宁科技大学本科生毕业设计(论文) 第III页 目录 摘要............................................................................................................................................I Abstract...................................................................................................................................II 1文献综述..............................................................................................................................1 1.1线材生产的基本知识........................................