大型在线液态出渣蓄热式高温硅钢加热炉方案设计书研究和应用.docVIP

大型在线液态出渣蓄热式高温硅钢加热炉 设计研究和应用 陈迪安1、李春生1、苗为人1、余威2、刘志民2 （1.北京首钢国际工程技术有限公司，北京 100043； 2.河北省首钢迁安钢铁有限责任公司，河北 迁安 064404） 摘要： 蓄热式燃烧技术具有高效、节能的优点，但将蓄热燃烧技术应用于加热高牌号取向硅钢大型在线液态出渣高温硅钢加热炉还没有先例，高温硅钢加热炉作为热轧硅钢生产线上高能耗设备，其燃烧系统的选择和确定已成为一个新的课题，加热炉供热方式的选择必须考虑工艺、燃料条件、加热钢种以及质量要求、操作维护、使用寿命、一次性投资成本、运行和维护费用等诸多因素。本文详细介绍迁钢1580mm热轧生产线高温硅钢加热炉先进炉型结构、蓄热和预热组合式燃烧技术、在线液态排渣技术、蓄热排烟系统“抽吸比”控制技术、蓄热烧嘴低负荷时序“间拔”控制等综合技术，不但提高了钢坯加热质量、降低了燃料消耗和污染物排放，同时高温硅钢加热炉周期加热量由5000t提高到11000t。 关键词： 蓄热式燃烧；抽吸比；在线液态排渣；“间拔”控制技术 Large-scale online liquid slag design study and application of regerative cumbustion high temperature silicon steel furnace Chen Di’an 1，Li Chunsheng1，Miao Weiren1，Yu Wei2， Liu Zhimin 2 Beijing Shougang International Engineering Technology Co., Ltd., Beijing, 100043; ?? ???2. Hebei Shougang Qianan Iron Steel Co., Ltd., Hebei Qianan, 064404) Abstract: Regenerative combustion technology has high efficiency, energy-saving advantages, but which is applied to a large online liquid high-grade oriented silicon steel heating furnace is no precedent, high temperature silicon steel heating furnace as hot-rolled silicon steel production line with high energy consumption equipment, combustion system selection and determination has become a new topic ,the furnace heating mode selection process, fuel conditions, heating steels and quality requirements, operation and maintenance, service life, the one-time investment costs, operation and maintenance costs, and many other factors must be considered. This paper describes Qiangang 1580 HSM production line of high-temperature silicon steel heating furnace the the advanced furnace structure, regenerative and preheat modular combustion technology, online exhaust slagging technology, regenerative exhaust system suction than control technology, regenerative burner low load timing pull control and other integrated technologies, not only to improve the quality of billet heating, reduce fuel consumption and pollutant emissions, while the high-temperature silicon steel heatin