第05单元 叉车安全操作.ppt

叉车操作 叉车安全驾驶 (一)日常应做例行检查及保养工作 (二)货物安放 (三)常见之操作错误 (四)货叉、链条之安全标准 (五)电池使用守则 (六)如有可能，参与叉车安全驾驶课程 驾驶员以经过适当训练和指定人员为限 您是否适合工作为铲车驾员? 对于这一车辆的驾驶方法，熟悉吗？ 有否戴上安全头盔，在工作时有否穿着工人衣？ Only properly trained and authorized drivers should operate forklift trucks Are you qualified to be a forklift driver?Are you familiar with the forklift truck you operate?Do you wear a safety helmet and proper clothing on the job? (二)货物安放 绝对不能过载 检查有无过载，一定要按铲车载重能力，进行装卸。 在货物装上叉以前，要确定一下货物重量，重心位 置。安全运转的第一条，在于理解叉车能力，加以 严密遵守。 Don’t overload Check load weights and handle only within the rated Capacity or your forklift truck.Before picking up a load ,be Sure of how much it weights and where its load center is located.Safe operation requires understanding and observing the forklift truck’s rated load capacity. 　(三)常见之操作错误 　(三)常见之操作错误 注意后端摆动在狭小通路或场所，应注意车辆后端摆动。铲车是利用后轮爬行之故，在转弯进，后端可能发生大的摆动。Watch rear end swingbecause the rear wheels steer your truck，the rear end swings wide when you trun。Use care in aisles and other tight plces。 * 安全要诀 TLGH W/H 2006/4/1 （本刊物内容只供参考之用） (一)日常应做例行检查及保养工作 在运转前，检查车辆情况 在开始一天的工作以前，考虑一下安全问题。车辆情 况不良、不能运转。如驾驶员认为不安全时、可以拒绝 运转。 Before starting work,check the condition of the forklift truck Stop and think safety before starting the day’s work.No truck should be operated unless it is im good working condi-tion.Refuse to operate a forklift truck which in your opinion is unsafe. 发现有任何故障时，应立即报告上司 在未恢复安全状态以前，不能运转。 应切记：”有了安全的铲车，才能保证安全的装卸。” Immedidtely report to your supervisor any obvious defects or required repairs A defective forklift truck or one requiring repairs should be taken out of service until it has been restored to safe operating condition.Remember,safe handing begins with a safe forklift truck. 每日完工后，检查铲车情况 应使您的铲车，保持最良好的健康状态。由于您 的细心保护，不但可以减少高额修理费用。更能 保证您本人的安全，以及您四周的人员和设备。 当有故障时，应立即报告上司。 Check the condition of your forklift truck after the day’s Work Keep your forklift truck in the best of health.Your personal Care will not only prevent costly repairs and reduce dow