鞋厂实习（Shoe factory practice）.docVIP

鞋厂实习（Shoe factory practice） Management practice diary First, the surface warehouse internship stage There are materials for making shoes such as fabrics and accessories, and the main materials are classified as follows: 1, leather, that is, natural leather; 2, polyurethane, referred to as PU; 3, PVC, referred to as PVC; 4, all kinds of weaving; 5 non-woven fabrics. The top coat of PVC is lacquer. The main component in the middle is polyvinyl chloride, and the lower layer is coated with adhesive. PU, commonly called synthetic leather, is lighter in weight. PU lines are paper patterns, that is, the PU pulp is coated on a textured release paper, cooled and then peeled off, so that the paper stays on the PU layer. PU can also be processed after embossing, from the production process, there are two kinds of wet and dry. The two are easily distinguishable. The wet method is usually thicker because there is a layer of BASE (low foaming layer) between the surface layer and the base cloth, and the dry rule has no BASE, so it is applied directly to the bottom of the cloth, so the comparison book and the pattern of Louis are deformed. Wet PU uses a wide range of luggage, handbags, shoes, balls, stationery, sofas and other aspects of the use of more, while the dry rule is mainly used in packaging and clothing. The first problem is the difference between the two PU and PVC, PU and PVC can be identified from a few ways: 1, PU feel softer than PVC, good quality, good toughness, generally used for fabrics, can withstand relatively large tensile force; The price of 2 and PU is more expensive than PVC; 3 and PVC can be ripped apart, and PU cannot; At the end of 4, the general PVC cloth is relatively thin, relatively thin; PVC more water and sweat cloth at the end of the needle cloth, PU cloth bottom quality is relatively high; the PVC leather base is generally textile cloth and knitted fabric, PU leather base is non-woven fabric; 5, if burned with PU, the flavor is relatively weak, P