网络工程与综合布线技术试题（Network engineering and integrated wiring technology examination questions）.doc

网络工程与综合布线技术试题（Network engineering and integrated wiring technology examination questions） Network cabling and testing review refer to a fill in the blanks 1, from the design point of view, the generic cabling system is generally divided into work area, equipment room, into the line, wiring subsystem, trunk system, building blocks, subsystems and management of 7 parts. The 2 ends of the two subsystems respectively, trunk cable terminal connected to the equipment room building wiring equipment (BD) and the FD (Telecommunication wiring frame 3, floor wiring equipment is the entrance area, the exterior of the building and communication of information pipeline and can be used as entrance facilities and buildings distribution equipment installation site. In 4, twisted pair cable, different line to have different twist length, thus reducing the crosstalk. 5, whether the cable is wrapped with metal shielding layer, can be divided into shielding pairs of twisted wires and unshielded pairs of twisted wires two major categories. In the current integrated wiring system, in addition to some special occasions, unshielded twisted pair cables are usually used. 6. The fiber consists of 3 parts, the core, the cladding and the coating. 7. According to the transmission mode, the fiber can be divided into single-mode fiber and multi-mode fiber. 8. The common bidding methods include two forms: public bidding and invitation bidding. 9. According to the national standard, the maximum length of twisted pair cables of distribution subsystems is 90m. 10 、 the network topology of the wiring subsystem usually adopts the star network topology. There should be enough space between the 11, equipment installation equipment, general equipment room area should not be less than 10 square meters. 12. Pairs of twisted cables are generally ordered in boxes, and the length of each pair of twisted cables is 305m 13. The cable management mark usually has three types: the cable mark, the insertion mark and t