物理动能习题(Physical kinetic energy exercises).docVIP

  • 5
  • 0
  • 约8.63千字
  • 约 9页
  • 2017-09-14 发布于河南
  • 举报

物理动能习题(Physical kinetic energy exercises).doc

物理动能习题(Physical kinetic energy exercises)

物理动能习题(Physical kinetic energy exercises) Kinetic energy theorem exercise course First, the kinetic energy theorem is used to solve the multi process problem Example 1. At the initial velocity of 10m/s, a mass of 0.5kg is thrown vertically up. The maximum height of the object is 4m. The resistance of the air to the object remains the same, and the kinetic energy of the object is returned to the point of release. Two, use the theorem of kinetic energy to do the work done by the force of change In 2 cases, as shown in the figure, a ball from the higher ground H meters from the static free fall, ignoring air resistance, fall to the ground and stop h meters deep underground, a ball of mass m, the average drag for the ball in the process by the following fall to the ground. Three. Use kinetic energy theorem to solve the problem of multi force work Example 3. As shown, the object is placed at the bottom of an inclined plane with a dip angle of 37 degrees. The motion of the object begins at rest and moves upward along the slope under the constant upward tension along the inclined plane. F size is 2 times the weight of the object, the slope and the object dynamic friction factor is 0.5, the object moving 5m speed. (g=10m/s2) Class practice: 1, a bullet at a speed of 700m/s into a piece of wood, shot after the speed is reduced to 500m/s, the bullet can pass through the same block of wood _____. (fixed by a piece of wood with constant resistance). 2, one end of the string is tied with a small ball, in a smooth horizontal table top to do uniform circular motion, then in motion, the rope pulling force on the ball to do the work for. 3, the mass of M slider along the height of H, L long rough slope can only slow down, in the slider from the top of the slope down to the end of the process: () The work done by A and gravity to the slider is MGH B, and the work done by the slider to overcome the resistance is equal to MGH The work done by C and resultant force to the slider is MGH

文档评论(0)

1亿VIP精品文档

相关文档