USB引脚系统结构与应用的设计方案.docVIP

USB系统结构与应用的设计 摘 要 随着人民生活水平的提高和安全防范意识的增强，人们开始关心自己的生活和工作环境，不但要求周边环境的舒适化和人性化，对居住工作环境的安全化和智能化也提出了更高的要求，安防系统已经成为生活中必不可少组成部分。传统的安防系统主要依靠电话网播报警讯信息，但电话网易被破坏，且不适用于偏远地区等架设通信线路困难或不经济的地方。把各种报警传感器分别安装在不同位置，当出现异常情况时，相应的传感器会将无线信号发送至控制模块的无线接收电路，控制模块通过软件判断出异常情况的类型，通过串行口控制GSM模块发送相应的报警短信，几秒钟后，用户的手机上就可以接收到报警短信，提醒用户采取措施。当用户在现场时，可通过发送短信撤除报警功能(简称撤防)，防止报警器对用户行动的误报警。用户还可以利用计算机对存储于EEPROM中的报警记录进行读取，以及对报警系统进行设置。 Abstract With the improvement of peoples living standards and an enhanced sense of security, people began to care about their living and working environment requires not only the comfort of the surrounding environment and the humane, safe living and working environment and intelligent also raised a higher requirements, security systems have become an indispensable part of life. Security systems rely mainly on the traditional telephone network broadcast warning information, but phone Netease have been destroyed, and does not apply to remote areas such as set up lines of communication difficult or uneconomic areas. An infrared intellectual door based on PLC which is opened according to human body is introduced in this paper. First the principle of system was analyzed,then the scheme and work flow were illustrated,and the design of software and hardware were given. In the end,the configuration simulation was present to validate the design. The various alarm sensors installed in different locations, respectively, when the abnormal situation, the corresponding sensors will be wireless signal sent to the control module of the wireless receiver circuit, the control module software determine the type of anomaly, through the serial port to control GSM the module sends the corresponding alarm messages, a few seconds, the users mobile phone can receive SMS alerts to remind users to take measures. When the user in the field, it can remove the alarm by sending an SMS (hereinafter referred to disarm), to prevent the alarm to目 录 第一章 绪 言 1 第二章 系统原理 2 第一节红外线检测原理 2 第二节防止挤压原理 2 第三章硬件系统设计 4 第一节 保护单元