玻璃幕墙的施工方案及施工工艺（Construction scheme and construction technology of glass curtain wall）.doc

玻璃幕墙的施工方案及施工工艺（Construction scheme and construction technology of glass curtain wall） Construction scheme and construction technology of glass curtain wall Recommended answer 1. basic requirements (1) working conditions; 1) the curtain wall construction organization shall be designed, and the construction shall be carried out in strict accordance with the order of the construction organization design. 2) curtain wall should be started after the main structure is completed. As for the curtain wall of high-rise building, because of the time limit, the construction of the curtain wall should be carried out along the high section under the premise of guaranteeing the quality and safety. When the curtain wall is crossed with the upper main structure, reliable protective measures must be taken at the top of the structure and below the curtain wall. 3) curtain wall construction, the original structure of the main construction of the external scaffolding should be retained, and in accordance with the requirements of the curtain wall construction of the necessary changes (the scaffold from the main structure of the body is not less than 300mm). If the curtain wall is installed with a basket, the basket must be safe and reliable 4) the curtain wall construction shall be equipped with necessary safe and reliable lifting tools and equipment. 5) when the decoration project will cause pollution or damage to the curtain wall, the project should be arranged before the curtain wall construction, or should take reliable measures to protect the curtain wall. 6) the curtain wall construction should not be carried out under heavy wind and heavy rain. When the temperature is lower than -5 degrees, glass installation shall not be carried out, and sealant construction should not be carried out in rainy days. 7) should be controlled in the construction of the main structure and check fixed curtain wall on each floor (roof) surface elevation, line size and position deviation of embedded part