电力电缆头（Power cable head）.docVIP

电力电缆头（Power cable head） I. power cables Power cable head is divided into terminal head and intermediate joint, according to the installation site, there are indoor and outdoor type. According to cable head production and installation materials are divided into dry bag type, epoxy resin pouring type and heat shrinkable type and so on three kinds (1) dry bag type electric cable head installation. Dry bag type power cable head using plastic tape wrapped cable head installation without the use of filler, nor any shell, which has the advantages of small size, light weight, low cost and convenient construction, but only suitable for indoor low pressure (less than 1KV) plastic or rubber insulated power cable. Dry package power cable head is divided into indoor terminal head and indoor intermediate joint, according to the cable core cross section size, with one as the measurement unit. The quota contains 1 ST gloves, but the terminal box, protective box, lead sleeve and mounting bracket are not included in the cost, and shall be calculated separately. For the full plastic cable and rubber insulated power cable, the dry package cable head can not be provided with a terminal box, and the utility model belongs to the manufacture and installation of a simple package cable head. (2) production and installation of pouring power cable head. The cast type power cable head is made of epoxy resin casing and bushing, equipped with outlet fittings, and is made of epoxy resin composite after assembly. Epoxy resin is a kind of good insulating material, especially for its good initial electrical properties, high mechanical strength, easy molding, good oil resistance and good adhesion, it has been widely used. Mainly used for oil paper insulated cable, indoor and outdoor type two class, and to distinguish the middle joint pouring type cable terminal and pouring type cable, high voltage (less than 10kV) and low pressure (less than 1KV), according to the section of cable core size grade, wit