电工.doc（电工.doc）.docVIP

电工.doc（电工.doc） I. radio questions 1, because of a sudden power outage may cause large economic loss for the load (B). A, a class of load B, two kinds of load C, three kinds of load D, four kinds of load 2, in order to ensure the reliability of a class of power supply, a class of power supply must be (D). A, direct power supply by power plants, B, a reliable standby power supply C, by the line power supply D, more than two cable power supply 3 、 the transformer neutral point (B) grounding is supplied to underground power supply in coal mine power supply. A, strictly forbid B, not direct C, must D, general should 4, fuse melt current rating refers to (D). A and long maximum permissible current of melt B, fuse housing, long duration, maximum permissible current C, fusing current of melt D the maximum operating current that is not fused by the melt through the melt 5. The main purpose of calculating three-phase maximum short-circuit current in power supply system is (B). A, select the electrical equipment B, check the electrical equipment strength C, verify the sensitivity of short-circuit protection, D, and verify the sensitivity of leakage protection 6 、 coal mine power supply, mining area low voltage cable (A). A, aluminum and aluminum insulated cables are strictly prohibited B, aluminum core cable can be used, but aluminum package C can not be used. Aluminum core cable should be popularized D, copper core or aluminium core cable 7, two electric M1 and M2 machines are controlled by KM1 and KM2 respectively. If M2 is required to start after M1 startup, then (B). A connect the movable contact of M2 in series before the M1 coil Before B and M2, the dynamic contact of M1 is connected in series C connect the M2 contact with the M1 before the coil D connect the M2 contact with the M1 before the coil How do 8. pairs of loads supply electricity (A)?. A two independent power, B dedicated line, C single circuit, D and ABC are all right. 9. the time that the short-circuit curre