空压复习（Air pressure review）.doc

空压复习（Air pressure review） JZD-060 type drying tower operation One boot 1 close the air outlet valve, pressure relief valve, open the filter before and after the inlet and outlet valve, bypass valve closed, the dryer up to work pressure, open the air valve solenoid valve before and after, and adjust the air pressure to 0.45Mpa. 2 press the power box on the ON button, dryer, electric work. 3 slowly open the air outlet valve after the dryer is in operation. Two test and notice of normal operation of power on 1 check the adjustment pressure every hour is consistent with the original setting pressure, ensure the supply of re heating flow. 2 regularly check drying pressure to verify the correctness of valve opening and closing time 3 when the dryer is regenerated, the pressure in the tower shall not exceed 0.03Mpa, and the program settings of PLC shall not be changed at will. Three parking 1 close the inlet and outlet valves of the filter 2 press the power box on the OFF button to stop working, dryer. 3 close the air outlet valve. 4 slowly open the dryer pressure relief valve until the two drying tower pressure gauges are displayed to zero. Fault phenomenon, cause analysis, treatment method When regeneration, the heating indicator lamp is not bright all the time. The power supply is abnormal according to the nameplate rated voltage Loose or broken wires, find loose or broken line to be checked and repaired Inside the heater, the resistance wire is burnt and replaced Overheating indicator light (alarm), regeneration gas pipeline or other pipeline plug, find the plug to be repaired BXN-100 pressure swing adsorption process for nitrogen production One boot 1 send the power to the cold dry machine and the control cabinet, and send water to the cold drier. 2 switch the air switch of the cold drier, the control cabinet and the relevant single pole switch. 3 turn on the inlet and outlet valve of the cold and dry machine and the two ball valves in front of the automatic trap, and