立磨知识（Knowledge of vertical grinding）.docVIP

立磨知识（Knowledge of vertical grinding） Operation and maintenance of LM56.2+2S slag vertical mill [Chinese cement net] author: Xue Ping unit: [2010-06-03] From the angle of energy saving, it is the development direction of grinding technology to separate materials with different grindability and then mix them to prepare cement. In order to make full use of waste slag resource, and improve the environment of Shanxi, Changzhi iron and steel (Group) Ruichang India Cements Limited in 2002 the introduction of Germany Loesche company production of LM56.2+2S slag vertical mill, grinding of steel are respectively made of blast furnace slag, the specific surface area of 450~480 square meters / kg of superfine slag powder, using RP120 * 80+ 3.8 * 13m+O Sepa (N-2000) system made of clinker grinding surface area for 350380 M / kg clinker powder, mixing into BMH mixer, production of different grade cement. The operation and maintenance experience of slag vertical mill is introduced in this paper. 1 stable bed Maintain a stable bed, which is the basis of roller mill grinding and the key to normal operation. The thickness of the material layer can be adjusted by adjusting the height of the retaining ring, and the retaining ring is the key component of vertical grinding. The function of the material layer is to maintain a certain material layer of the grinding machine, and the wear degree of the retaining ring affects the stable operation of the grinder. The appropriate thickness and their relation to mill output should be mastered by the operator in the course of normal operation. The material layer is too thick, the grinding efficiency reduces, and the material layer is too thin, will cause the vibration. Such as rolling increased, the resulting fine powder more, the material layer thinning, roll less, grinding materials thickening, the corresponding return of more materials, material thickness. The wind speed in the mill increases, the internal circulation increases, the material l