结构设计标准（Structural design standard）.doc

结构设计标准（Structural design standard） Structural design standard.Txt love is a very tough word. The upper half of it is taken from abnormal, and the lower half is taken from the abnormal state. Structural design standard Structural design standard Lens: 1., the main screen lens as far as possible using die cutting, the main screen lenses using PMMA, the thickness of 0.8 2. lens: camera lens, as far as possible the use of die cutting, lenses using rigid glass, thickness 0.5 3. camera, camera angle is often 65, and camera lens intersection ratio, the camera after the screen printing area to unilateral small 0.25 4. screen lenses, screen printing area than LCD (A/A) unilateral big 0.5 Casing: 1., shell average material thickness: 1.2, best to do 1.4 2. common screen: shell opening ratio LCD (A/A) 1 unilateral, foam than hole unilateral 0.25 case 3. touch screen: TP casing opening ratio (V/A) of unilateral 0.5, than the shell hole unilateral large foam 0.3-0.5 4. all foam thickness 0.5 specifications, compression thickness of 0.3 5. all double adhesive thickness adopts 0.15 specifications, the model is 3M9495 6. when the enclosure is not required by the ID, the parting line should not be rounded and beveled 7. when the case is broken, if it is possible to scrape the hand in the later period, it should be 0.3*0.3 8. nut adopts: outer diameter 2.3*, length 3.0*, thread M1.4, shell stud: outer diameter 3.8*, inner diameter 2.1 9. screws were used: M1.4*3.0, head thickness 0.75, cross, and the surface was black The 10. shell stud diameter 2.3* cutting height of 0.25 heavy Taiwan, stud nut 2.1 deep hole 0.3, for overflow 11., the housing commonly used 6 screws, AB shell stud gap 0.1., straight mouth 0 clearance. Length is greater than 30, must increase the buckle The 12. button 0.6, female buckle depth do 0.9, then with the amount of follow-up can be lengthened. The female buckle holes are not allowed to even gum 0.3, side and top edge of a material thickness must reach 1, ensu