有线电视（Cable TV）.docVIP

有线电视（Cable TV） [residential] residential area cable television system design (2010-12-29 10:44:06) reproduced the original label: reproduced Youxiandianshi Original address: residential area cable system design, the author: wayven Overview of a.CATV system design The cable television system with adjacent frequency transmission using adjacent frequency transmission system channel capacity, high stability, nonlinear distortion, the front-end system has a variety of antenna, modulator, demodulator, multi-channel RF signal mixer. At present, there are three modes of cable TV transmission in our country, namely cable transmission, cable transmission and microwave transmission. The cable TV system adopts optical fiber transmission. CATV distribution system is a system that provides an appropriate TV signal to each user terminal of the system by distributing network (including branch, distributor, user distribution amplifier and radio frequency cable). The system uses the distribution branch form, from the user distribution amplifier output signals are divided into a few ways through the distributor, each road and then through different branches to the end-user to meet the requirements of the signal. Every summer, due to thunderstorms and climate change, it is the peak season of cable TV system failure. Lightning is very harmful to the cable TV system, so lightning protection, lightning protection and grounding have become important issues that can not be ignored in CATV system design. The system on how to do the relevant network lightning protection measures are explained. Two. Front-end systems, equipment and design As the beginning of cable TV transmission, the front end system is the most important part of CATV system and the heart of cable TV system. The quality of the front end signal directly affects the quality of the users signal. The front end uses adjacent frequency transmission, and the front end design configuration diagram is shown below. Primary election of