汽车起重机长杆磨削的防废措施（Anti waste measures for grinding of long rod of automobile crane）.docVIP

汽车起重机长杆磨削的防废措施（Anti waste measures for grinding of long rod of automobile crane） Anti waste measures for grinding of long rod of automobile crane 8-29 The grinding of the piston rod (long rod) of an automobile crane telescopic cylinder is easy to produce waste. According to our experience, there are the following measures to prevent waste. 1. carefully measure the left wear of each part of the workpiece We should judge whether the grinding on the workpiece bending, deflection, dislocation and mark depth data. (1) for grinding allowance not exceeding 0.50mm parts by the operator carefully measured numerical deflection, bending, dislocation, marks etc.. If the amount of grinding is less than 0.20mm, we must ask the relevant staff for approval before grinding. (2) if the deflection or bending is over 1/3 of the amount of grinding, it should be straightened and then ground. (3) data measured deflection data and diameter on both sides of the dislocation sites on both sides of the mill, the amount of available minimum diameter at maximum deflection value minus the position deflection value, the difference is the amount of actual grinding. Such as: dislocation grinding quantity minimum diameter is 0.40mm, the deflection of the location of the maximum deflection value is 0.30mm, the actual grinding quantity is equal to 0.40 - 0.30 = 0.10mm, the amount of grinding is very few, is likely to occur in the grinding burn condition, resulting in waste. (4) cut deep parts, grinding before the best use file to the local symmetry point (the most severe and partial areas) filing a small plane two symmetrical, measured in terms of the site file. If the measured diameter minus the track diameter less than 0.20mm, should also consult before grinding. 2. properly handle the burn in grinding (1) before the inspection according to the requirements of grinding grinding, if the coarse grinding sparks, large local burns, and after two times of reciprocating grinding burn also cannot be elimina