波形梁钢护栏的施工方案、施工方法（Construction scheme and construction method of corrugated beam steel guardrail）.docVIP

波形梁钢护栏的施工方案、施工方法（Construction scheme and construction method of corrugated beam steel guardrail） The first section is the construction plan and construction method of corrugated steel guardrail I. construction methods and plans In order to ensure the engineering quality reach the standard of excellence, according to technical specifications for design and construction of highway traffic safety facilities, according to the design documents and inspection standards, we will send professional and technical personnel to the professional component manufacturers on the whole process of quality control. At the same time, the construction site technical staff a careful survey of the site, the necessary level of the construction site, and then complete the measurement lofting, everything began to wave beam installation is ready, specific programs are as follows: (1) preparation for construction Before the start of construction, construction and technical personnel familiar with and understand the design drawings and related construction specifications, and the construction personnel went to the construction site and design drawings check, find the road construction pile, various structures and structural barriers place, do the construction equipment and materials of construction work at the same time. 1, steel guardrail column lofting The column should be carried out according to the layout design drawings, and to the bridge, tunnel and culvert, interchange, crossing etc. as the control points of the location, can be adjusted by adjusting the spacing, and allocation method based on interval number fraction. For accurate lofting and ensuring the alignment of the guardrail, the section number is checked and closed. The column, lofting each column should be investigated after the position of the ground state, such as the case of underground communication pipeline and water discharge, or on the top of the culvert buried depth is insufficient, should adjust certain column positio