TUV榨汁机测试报告.doc

Standard: IEC/EN 60335-1; IEC/EN 60335-2-14; EN 62233:2008 Order No.: Client: Product: Centrifugal Juicer Rated voltage (V/Hz) 230V / 50Hz Project Engineer: Rated input (W/A) Test Engineer: Protection class: I II III Application Date: 2011-02-11 Protection against moisture: IP 20 Requested Date: Construction: portable fixed hand-held stationary built-in Re-test: Operation mode: continous intermitten short time KB___min Full-test: Weight (kg): Other information: Result Clause(s) Test(s) Page F P 7.14 Rubbing test for rating label F P 8 (8.1,8.2 except for 8.1.4) Accesses to live part F P 10 Power input and current test F P 11 Normal heating test F P 15.2 / 16.3 Spillage test F P 15.3/16.2/16.3 Humidity test/ Leakage current /electric strength test (after humidity treatment) F P 19.7 Stall motor test F P 19.10 Over voltage test for series motor F P 20.1 Stability test F P 20.2 Protection to access dangerous moving part F P 20.117 Special test for sieve F P 21.1 Mechanical strength test F P 22.5 Discharge test for capacitors F P 22.11 Detachable part F P 22.12 Detachable knob F P 23.5 Electric strength test for insulation of internal wiring F P 25.15 Cord anchorage test F P 29.1/29.2/29.3.1 Clearance/ creepage distance/ solid insulation F P 30.1 Ball Pressure Test F P 30.2.1-3 Glow-Wire test F P EN62233 EMF test Total page?: _______pages Date Signature Date Signature Record by Test Engineer Check by Project Engineer  DURABILITY OF MARKING (7.14) ( N/A ( Fail ( Pass Compliance is checked by inspection and by rubbing the marking by hand for 15s with a piece of cloth soaked with water and again for 15 s with a piece of cloth soaked with petroleum spirit. After all the tests of this standard, the marking shall be clearly legible, it shall not be easily possible to remove marking plates and they shall show no curing. Marking / Location Under Test 15 s with water 15 s with petroleum