隔热膜施工工艺与过程.docVIP

WINDOW FILM CONSTRUCTION METHODS AND PROCESS 太阳隔热膜施工工艺及过程  1、 Preparation at the construction site 1、在施工现场准备Determine construction areas according to construction drawings and make preparation of construction in teams. 1.1 确定建筑面积按施工图纸，并在团队中的施工准备。Determine material stacking and blanking locations. 1.2确定材料堆放和位置。  Check construction tools and safety measures, such as ladder safety etc. 1.3 检查施工机具和安全的措施，如梯安全等， Further make preparation for protection and prevention. 1.4 进一步做好保护和预防的准备 Construction methods 2、施工方法 2.1 Glass cleaning 2.1 清洁窗户 Check whether there are any dirty marks such as soil dust, paints or silicone glue on glasses before spraying and wetting glasses. Use scouring pad to remove the dirt as necessary and clear away the dust with brushes. Spray washing and installation liquid on the whole glass, and use the cleaning scouring pad to clean the whole window glass. Use the clean dish cloth to clean the window frames. 在喷湿窗子之前，先检查玻璃上是否有泥尘、油漆、或硅酮胶等污物。必要时用刀片将污物清除，然后用硬刷把尘埃扫去。将整快玻璃喷上清洗安装液，然后用清铲刀将整个窗玻璃刮铲。用一块柔软的毛巾擦洗窗框四周，把窗框边缘擦洗干净。 Window film preparation 2.2 准备窗膜 Currently three common methods are used to prepare window film. 目前有三种常用的方法准备窗膜 Method 1: Use other glass as the backer. 2.2.1 方法1：以其他窗户为垫板， Use a piece of glass that has been cleaned initially as the backer, sprinkle water on the window and place the window film to be installed on it. The protective film of the window film shall be placed towards yourself. 先找一个初步清洁的窗子做垫板，在窗上洒水后，把将要安装的窗膜置于其上，窗膜的保护膜面向自己。 Method 2: Reversal roll method 2.2.2 方法2：反转卷轴法 Roll the window film reversedly towards the box side carefully, with the protective film facing upwards. The rolling diameter of window film shall be about 2.5cm. While about 8cm long window film is left after rolling, cut the film along the box edge. Grip the rolled window film at hands, and then start to tear protective film. Tear the film carefully, and roll the protective fill towards the roll core. Spray installation liquid to glue it