单片机脉冲控制器课程设计报告.docVIP

信息与电气工程学院 课程设计说明书 （2012-2013学年第2学期） 课程名称 ： 单片机课程设计 题 目 ： 脉冲控制器 专业班级 ： 学生姓名 ： 学 号 ： 指导教师 ： 设计周数 ： 2周 设计成绩 ： 2013年07月11日  目 录 １.　 课程设计目的·························································1 ２.　 课程设计正文························································1 ２.１ 　功能介绍···························································1 ２.２.１ 电路原理····························································1 ２.２.２　 proteus原理图························································2 ２.２.３ 　 各功能模块电路设计························································2 ２.２.３.１ 　LED和蜂鸣器模块························································2 ２.２.３.２ 　 硬件复位模块和晶振模块····················································3 ２.２.３.３ 段码输出和共阴极数码管模块················································3 ２.２.4　 PCB图································································4 ２.２.5　 共阴极数码管显示码对照表·····················································4 ２.３　 元件清单··························································5 ２.４ 实际电路板成品图·························································6 ２.５　 程序流程图···························································7 ２.６ 　程序····························································8 ２.６.１ 　C程序源代码···························································8 ２.６.２　 代码分析························································9 3． 课程设计结论··························································10 4. 参考文献··························································10 1、课程设计目的 通过具体的功能电路进一步熟练proteus与keil连调功能及protel99se的应用，进一步熟练焊接技术，掌握万用电路板的使用方法和技巧，初步掌握单片机编程和调试的技能，例如本课题的数码管显示模块，中断程序设计等。学会利用相关工具检查电路和借助计算机或仿真仪器单步调试程序。注重团队合作，合理组织分工作业，耐心细心，不怕困难，各尽其力，勤动手动脑，善于分析问题，灵活解决问题，提出设计思路，模块组合与技巧的实际操作。通过这些具体的体验，为以后步入岗位从事相关单片机电路设计工作打下基础。 2、课程设计正文 ２.１　功能介绍 脉冲控制器可以实现手动加减计数。k1为加计数键，k2为减计数键，数码管可以显示０～９、Ａ、ｂ、Ｃ、ｄ、Ｅ、Ｆ。另外当显示为“