计算机干净启动（Computer clean start）.docVIP

计算机干净启动（Computer clean start） Answer: clean startup is similar to security mode. When you start your computer in this mode, you run only the minimum number of startup programs and services. For example, if you did not make a mistake when you started the computer in safe mode, it might have been a startup or service that caused the problem. In the clean start to solve the problem, you can try to close all the procedures and start the service when the computer is started, then the system to open or close the start, until you can start to find out the cause of this error clear. Step 1: perform clean start Note: network policy settings may prevent you from performing these steps if your computer is connected to the network. We strongly recommend that you do not use the system configuration utility to modify Advanced startup options on your computer unless the Microsoft technology support engineer instructs you to do so. This operation may cause the computer to be unavailable. 1. log on to the computer using an account with administrator privileges. 2. click the start button, type msconfig.exe in the start search box, and then press Enter to start the system configuration utility. 3. on the General tab, click Select startup, and then click Remove the load startup items check box. (the use of the original Boot.ini check box is not available.) 4. on the Services tab, click to select the hide all Microsoft Services check box, and then click disable all. Note: following this step, the operation will enable the Microsoft service to continue. These services include networking, plug and play, event logging, error reporting, and other services. If you disable these services, you may permanently delete all restore points. Do not perform this restore if you need to use the system restore utility with the existing restore point. 5. click OK, and then click restart. Step 2: enable half service 1. start the system configuration utility in step 1a and 1b operations. 2. click the Servi