诊断功能的使用（The use of diagnostic function）.docVIP

诊断功能的使用（The use of diagnostic function） The use of diagnostic function After the NC system fails, if there is no alarm information, the fault diagnosis is carried out through the diagnostic picture of the system. When the machine tool is abnormal, the alarm signal and the monitoring data provided by the diagnosis function provide the basis for judging the fault. MDI-system- diagnosis For notes on diagnostic numbers, see Appendix 2 2 、 diagnose faults with diagnostic function How do you effectively use diagnostic information provided by diagnostic features to help find and troubleshoot faults? This must be our biggest concern. Then learn how to use diagnostic features to solve some of the hidden failures that often occur in practice. (1) when the diagnostic number 000 is 1, it indicates that the system is performing an auxiliary function (M instruction). In the execution of the auxiliary function, No. 000 will remain 1 until the secondary function is complete and the signal arrives. Therefore, when the secondary execution time of the auxiliary function exceeds the normal value, the condition of the auxiliary function may not be satisfied. So there is no alarm abnormalities, to find the fault point, if the diagnosis of 000 is 1, you can first check whether the auxiliary function to complete the machine tool movements have been completed. Fault phenomenon: a CNC machine tool in the automatic running state, whenever the implementation of M8 (cutting fluid spray) this auxiliary function instructions, the processing program will no longer go down. At this point, the pipe is a cutting fluid jet, the system does not have any warning tips. Elimination: V diagnosis function picture, diagnosis No. 000 is 1, that is to say the system is performing auxiliary function, cutting fluid spray of the auxiliary function is not complete (in the system failed to confirm whether the cutting fluid has ejected, and the fact that the cutting fluid has been ejected). Therefore, consult the el