超声波（Ultrasonic）.docVIP

超声波（Ultrasonic） Ultrasonic examination questions Release date: 2010-10-4 [collection comments did not find the desired knowledge] 1. ultrasonic testing, 1MHz probe resolution than 5MHz probe resolution (b): A. high, B. low C., the same D. above are wrong 2. when a beam of ultrasound obliquely hits a heterogeneous interface, the possible phenomenon is (d): A. wave mode transformation, B. refraction, C. reflection, and D. above all 3. by ultrasonic wave in the far field detection of two flat holes with the same diameter, a sound path for 100mm, another is 300mm, regardless of material attenuation under the condition of two flat bottom hole pressure echo difference (d): a.9.5dB b.12dB c.24dB D. is right above The 4. oblique probe made of organic glass as wedge detecting S-wave velocity of 3080 M / s for aluminium, aluminum in that wave refraction angle of 60 degrees, while the incident angle of the probe is about (b): a.28 above b.49 c.55 DEG 42DEG 24 DEG 18D. is right The lead zirconate titanate wafer used for 5.2.5MHz probes is approximately Nt=2100KHz.mm (c) a.1.5mm b.0.05mm c.0.8mm d.2.5mm 6., the ratio of the acoustic velocity of the two materials is called (d): A. interface, acoustic impedance, B., Youngs modulus, C. Poissons ratio, and D. refractive index 7. ultrasonic sound speed is mainly determined by (c): the density and elasticity of A. medium, the mode of vibration of B. particle in medium, C.A and B are d. acoustic impedance 8. of the sound beam is a linear focusing acoustic lens is a cylindrical surface (a): A. B. C. D. spherical surface square prism The energy of the 9. probe beam is concentrated in the far field region (b) The A. beam edge is the largest, the B. beam center is the largest, and the C. beam center is as large as the edge, and the D. is inversely proportional to the beam width 10. the influence of temperature on water sound velocity is (a) A. water temperature rises, sound speed becomes larger, B. water temperature rises, sound speed beco