跌落试验（Drop test）.doc

跌落试验（Drop test） Peoples Republic of China national standard Package, transport package Drop test method GB/T 4857.5-92 instead of GB4857.5-84 -------------------------------------------------------------------------------- This standard is equivalent to ISO2248-1985 packaging - complete, fully packed transport packages - vertical impact drop test. 1, the subject content and scope of application This standard specifies the main performance requirements, test procedures and test reports for the test equipment used in the vertical impact test of transport packages. This standard is used to assess the impact resistance of transport packages in case of vertical impact and the protection of packing to the inside. It can be used as a single test or as part of a series of tests. 2 citation criteria Marking method for each part of GB/T 4857.1 packaging and transport package test GB/T 4857.2 packaging, transportation, packaging, temperature and humidity regulation GB/T 4857.17 packages; transport packages; preparation; performance test programs; general principles GB/T 4857.18 packages; transport packages; preparation; performance test programs; quantitative data 3 test principle Lift the test sample to a predetermined height, then free to fall in a predetermined state and collide with the impact table. 4 test equipment 4.1 impact table The impact table is horizontal and does not move without deformation during the test and meets the following requirements: A. is a whole object, the quality is at least 50 times the quality of the test sample; The B. should be large enough to ensure that the test sample falls completely on the impact table; C. on the impact table, the horizontal height of any two points shall not exceed 2mm; D. on the impact surface, when any area of 100mm2 is subjected to the static load of 10Kg, its deformation shall not exceed 0.1mm. 4.2 lifting device The test sample shall not be damaged during the lifting or lowering process. 4.3 support device The device